To tackle the corners of the room, simply cut a carpet gripper down to size, so that it fits perfectly into the space. There are three main challenges that you may face during this process: This allows just enough space for the carpet to be tucked in around the edges. Position each carpet gripper approximately 10mm away from the skirting board, with the pins facing up and pointing towards the wall. The gripper pins are extremely sharp and you should take care not to cut yourself. It’s usually worth wearing a pair of thick leather gloves for this stage. You’re now ready to start the fitting process. If any are detected, you can mark out their exact position – and use gripper adhesive rather than nails to secure grippers in these areas.

It’s also a good idea to check for underfloor wires and pipes. Be sure to remove any dust, dirt and debris that is left behind from the previous flooring. Prepare the subfloorīefore laying new carpet grippers, you should always prepare the area and clean the surface of the subfloor. So, get out your trusty tape measure, take accurate measurements, and do the calculations.

They will need to be fitted around the full perimeter of the room. Strips are typically sold in 150cm lengths or DIY 76cm lengths, but they can be easily cut down to size for corners, curves and obstructions. A step-by-step guide to fitting carpet gripper rods Do the mathsįirst things first, you need to work out how many carpet grippers you actually need. Here we offer a step-by-step guide on how to lay them correctly, hopefully keeping mistakes (and frustration levels!) to a minimum. So, you’ve chosen to do-it-yourself and install your own carpet? That’s great! But do you know how to fit carpet grippers? These long pieces of plywood may not seem very important, but to create a smooth, professional finish, they’re an absolute essential to fit a carpet.

Gripper for windows instal